![]() ![]() When your design is error-free, the following message displays and the Build Circuit button becomes active: Adjust your parameters and click Verify again. If there are any problems with your design, a message displays below the diagram in the Filter Wizard dialog box. Note: The available parameters change depending on the selections made in the above steps. Enter desired filter parameters in the box below the Type drop-down list.Select the desired ripple in the Pass Band Ripple box (for Chebyshev type filters only).Select the desired source impedance in the Source Impedance box (for passive filters only).If you select Passive, the Source Impedance box displays. Select either Passive or Active in the Topology box.If you select Chebyshev, the Pass Band Ripple box displays. Select either Butterworth or Chebyshev in the Type box.The parameters that are available in the box below the Type drop-down and the diagram on the right of the dialog box will change based on the selected filter type and selections made in the following steps. Choices are low pass, high pass, band pass or band reject. Select the desired filter type from the Type drop-down list.Select Tools>Circuit Wizards>Filter Wizard.To design a filter using the Filter Wizard: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |