I contacted Gendan yesterday and the adviser was unsure too. My router is only a meter or two away from my car in the drive anyway so a connection has been live when using the VCDS in the car this whole time. Thanks.Ĭlick to expand.Thank you for the suggestion, before connecting anything to the car I made sure both the software and drivers updated in the house. I will be posting on the Ross Tech forum too once I am verified to post. Am I doing something wrong? Any suggestions would be much appreciated.Īpologies as this isn't really Audi TT specific, but I can imagine there are quite few experienced VCDS users on here. However since then I just keep getting the same error message on ignition or with the engine running. I have managed to run one successful scan which ran through each module but that was with the engine running. Everything is connecting fine (led on cable flashing green) and I am testing the connection before running the scan which is saying "OK" as per below screenshot. However when I try and run an auto-scan I keep getting the message "function not supported by the gateway" as per below screenshot. I have registered the product and have even registered my VIN to the cable. Hi guys, so I had my copy of VCDS delivered the other day from Gendan (HEX-V2 fully registered with Ross Tech) and I'm having a little trouble with simply running an auto-scan.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |